ED031120 - Mig Wire Lincore 55 .045 25 lb Spool Flux cored Hardfacing

This product features low alloy steels that are specifically designed for rebuilding carbon or low alloy parts used in Metal-to-Metal wear applications. These steels are most effective in non-lubricated rolling or sliding scenarios.

It operates on a voltage of 31(Volt) and has a wire feed speed of 500(in/min). With DC+ Polarity on Current, it offers a range of 80-165(AMPs). The deposition rate for metal-to-metal hardfacing is a maximum of 9.4(lb/hr).

For shielding gas, it can be used with either 75-90% Argon / Balance CO2 or 98% Argon / 2% O2. It is suitable for all welding positions except overhead.

When using LINCORE® 55-G, it is essential to work in a clean area, free from any previous hardfacing deposits, with properly repaired cracks. Cold parts should be warmed to at least 25ºC (75ºF). For thick parts or heavy sections, a higher preheat of 150° - 260ºC (300° - 500°F) is recommended. The composition and properties of the deposit depend on the level of dilution, while single layer deposit properties rely on the base metal and/or build-up material.